Machining the workpiece
5.10 Editing a program
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
153
Enter the default settings in the "Settings" window that are to take effect automatically when
the editor is opened.
Number automatical-
ly
• Yes: A new block number will automatically be assigned after every line
change. In this case, the specifications provided under "First block num-
ber" and "Increment" are applicable.
• No: No automatic numbering
First block number Specifies the starting block number of a newly created program.
The field is only visible when "Yes" is displayed under "Number automatical-
Increment Defines the increment used for the block numbers.
The field is only visible when "Yes" is displayed under "Number automatical-
Display hidden lines
• Yes: Hidden lines marked with "*HD" (hidden) will be displayed.
• No: Lines marked with ";*HD*" will not be displayed.
:
Only visible program lines are taken into account with the "Search" and
"Search and Replace" functions.
Display block end a
The "LF" (line feed) symbol ¶ is displayed at the block end.
Line break
• Yes: Long lines are broken and wrapped around.
• No: If the program includes long lines, then a horizontal scrollbar is dis-
played. You can move the section of the screen horizontally to the end of
the line.
Line break also in
standard cycles
• Yes: If the line of a cycle call becomes too long, then it is displayed over
several lines.
• No: The cycle call is truncated.
The field is only visible when "Yes" is displayed under "Line break".
Visible programs
• 1 - 10
Select how many programs can be displayed next to one another in the
editor.
• Auto
Specifies that the number of programs entered in a job list or up to 10 se-
lected programs will be displayed next to each other.
Width of the program
Here, you enter the width of the program that has the input focus in the editor
as a percentage of the window width.
To Next Page
Loading...
Need help?
General
