Introduction
2.4 User interface
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
51
Entering or selecting parameters
When setting up the machine and during programming, you must enter various parameter
values in the entry fields. The background color of the fields provides information on the
status of the entry field.
The input field is selected
The input field is in edit mode
The entered value is incorrect
Some parameters require you to select from a number of options in the input field. Fields of
this type do not allow you to type in a value.
The selection symbol is displayed in the tooltip:
Associated selection fields
There are selection fields for various parameters:
● Selection of units
● Changeover between absolute and incremental dimensions
Keep pressing the <SELECT> key until the required setting or unit is
selected.
SELECT> key only works if there are several selection options
<INSERT> key.
The selection options are displayed in a list.
Select the required setting using the <Cursor down> and <Cursor up>
keys.
If required, enter a value in the associated input field.
Press the <INPUT> key to complete the parameter input.
To Next Page
Loading...
Need help?
General
