Siemens SINUMERIK 828D User Manual

Tool management
12.9 Tool details
Turning
708 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
5.
Press the "Cutting edge data" soft
key if you wish to display the cutting
edge data.
6.
Press the "Monitoring data" softkey if you want to display the monitoring
data.
12.9.2
Tool data
The "Tool Details" window provides the following data on the selected tool when the "Tool
data" softkey is active.
Parameter
Meaning
Magazine location The magazine number is specified first, followed by the location number in the magazine.
If there is only one magazine, only the location number is displayed.
Tool name The tool is identified by the name and the sister tool number. You can enter the name as text or
number.
ST Sister tool number (for sister tool strategy)
D quantity Number of created cutting edges
D
Cutting edge number
Tool state
A
Activate tool
F
Tool enabled
G Block tool
M
Measure tool
V Reaching the prewarning limit
W
Tool being changed
P Tool in fixed location
The tool is permanently assigned to this magazine location
I Tool has been in use
Tool size
Standard Tool does not require an additional location in a magazine.
Oversize The tool occupies two half locations left, two half locations right, one half
location top and one half location bottom in a magazine.
Special size
Left Number of half locations to the left of the tool
Right
Number of half locations to the right of the tool
Tool OEM parameters
1 - 6
Freely available pa-
rameters

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English