Siemens SINUMERIK 828D User Manual

Programming technology functions (cycles)
9.3 Contour turning
Turning
420 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Parameter
Description
Unit
Allowance Allowance for pre-finishing - (only for ∇∇∇)
• Yes
U1 contour allowance
• No
U1 Compensation allowance in X and Z direction (inc) – (only for allowance)
• Positive value: Compensation allowance is kept
• Negative value: Compensation allowance is removed in addition to finishing
allowance
mm
* Unit of feedrate as programmed before the cycle call
Hidden parameters
Parameter
Description
Value
Can be set in SD
Residual material
With subsequent residual material removal
No
SC Safety clearance x
DI
Continuous cut - (only for ∇)
0
Set machining area
limits
Set machining area limits No
N
Number of grooves
1
Machine manufacturer
Please r
efer to the machine manufacturer's specifications.
9.3.11
Plunge-cutting rest (CYCLE952)
Function
The "Grooving residual material" function is used when you want to machine the material
that remained after grooving along the contour.
During grooving ShopTurn, the cycle automatically detects any residual material and
generates an updated blank contour. For a G code program, the function must have been
previously selected. Material that remains as part of the finishing allowance is not residual
material. The "Grooving residual material" function allows you to remove unwanted material
with a suitable tool.
Software option
To machine residual mater
ial, you require the "Residual material detection
and machining" option.

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English