Siemens SINUMERIK 828D User Manual

Managing programs
13.18 RS-232-C
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
783
13.18.2
Setting V24 in the program manager
V24 setting
Meaning
Protocol The following protocols are supported for transfer via the V24 interface:
• RTS/CTS (default setting)
• Xon/Xoff
Transfer It is also possible to use a secure protocol for data transfer (ZMODEM
protocol).
• Normal (default setting)
• secure
For the selected interface, secure data transfer is set in conjunction
with handshake RTS/CTS.
Baud rate Transfer rate: Transfer rates of up to 115 kbaud can be selected. The
baud rate that can be used depends on the connected device, the
cable length and the general electrical conditions.
• 110
• ....
• 19200 (default)
• ...
• 115200
Archive format
• Punched tape format (default setting)
• Binary format (PC format)
V24 settings (details)
Interface
• COM1
Parity Parity bits are used for error detection: The parity bits are added to the
coded characters to make the number of positions set to "1" an uneven
number (uneven parity) or to an even number (even parity).
• None (default setting)
• Odd
• Even
Stop bits Number of stop bits for asynchronous data transfer.
• 1 (default)
• 2
Data bits Number of data bits for asynchronous data transfer.
• 5 bits
• ...
• -8 bits (default setting)
XON (hex)
Only for punched tape format
XOFF (hex)
Only for punched tape format

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English