Machining the workpiece
5.10 Editing a program
Turning
144 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
With the editor, you are able to render, supplement, or change part programs.
Note
Maximum block length
The maximum block length is 512 characters.
● The editor is started via the "Program correction" softkey in the "Machine" operating area.
You can directly change the program by pressing the <INSERT> key.
● The editor is called via the "Open" softkey as well as with the <INPUT> or <Cursor right>
key in the "Program manager" operating area.
● The editor opens in the "Program" operating area with the last executed part program, if
this was not explicitly exited via the "Close" softkey.
Please note that the changes to programs saved in the NC memory take immediate
effect.
If you are editing
on a local drive or external drives, you can also exit the editor without
saving, depending on the setting. Programs in the NC memory are always
automatically saved.
Exit the program correction mode using the "Close" softkey to return to the "Program
manager" operating area.
Editor settings (Page 153)
Correcting a program (Page 129)
Opening and closing the program (Page 738)
Generating a G code program (Page 221)
To Next Page
Loading...
Need help?
General
