Siemens SINUMERIK 828D User Manual

Multi-channel machining
10.2 Multi-channel support
Turning
626 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
10.2.5.2
Editing a G code multi-channel program
Editing a G code multi-channel program
Precondition
● The "programSYNC" option is set.
● In order to display the machining at the counterspindle at the correct position in the
simulation, the linear axis of the counterspindle must be positioned before CYCLE208
(multi-channel data).
Machine manufacturer
Plea
se refer to the machine manufacturer's specifications.
Procedure
1.
Position the cursor i
n the "Workpieces" folder on a job list and press the
"Open" softkey.
Note:
If the cursor is located on a workpiece, then a search is made for a job
list with the same name.
The "Job list ..." window opens and the program assignment to the
channels is displayed.
2.
Press the "OK" softkey.
The programs are displayed next to one another in th
e editor.
3.
Position the cursor on the first block of the program (multi
-
channel data)
and p
ress the <Cursor right> key.
The parameter screen "Multi-channel data" is opened.
4.
Enter the required values if you wish to change cross-channel data.
Adding multi-channel data in a G code program
You have the possibility of adding the multi-channel cycle (CYCLE208) subsequently.

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English