Siemens SINUMERIK 828D User Manual

Managing programs
13.16 Backing up data
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
773
9.
Select the required location for archiving and pre
ss the "New directory"
softkey to create a suitable subdirectory.
The "New Directory" window opens.
10.
Enter the required name and press the "OK" softkey.
The directory is created below the selected folder.
11.
Press the "OK" softkey.
The "Generate Archive: Name" window opens.
12.
Select the format (e.g. archive ARC (binary format) for 840D sl and/or
Archive ARC for 828D), enter the desired name and press the "OK"
softkey to archive the file(s).
A message informs you if archiving was successful.
13.
Press the "OK" softkey to confirm the message and end the archiving
operation.
An archive file in the .ARC (8
40D sl) or .ARD (828D) format type is cre-
ated in the selected directory.
13.16.3
Reading in an archive in the Program Manager
In the "Program Manager" operating area, you have the option of reading in archives from
the archive folder of the system data as well as from configured USB and network drives.
Software option
In order to read
-in user archives in the "Program Manager" operating area,
you require the option "Additional HMI user memory on CF Card of NCU" (not
for 840D sl / SINUMERIK Operate on PCU50 / PC).
Procedure
1.
Select the "Program Manager" operating area.
2.
Press the "Archive" and "Read in archive" softkeys.
The "Read in archive: Select archive" window opens.
3.
Select the archive storage location and position the cursor on the
required archive.
Note:
When the option is not set, the folder for user archives is
only displayed if the folder contains at least one archive.
- OR -

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English