Siemens SINUMERIK 828D User Manual

Programming technology functions (cycles)
9.7 Additional cycles and functions in ShopTurn
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
581
9.7.3
Transformations
To make programming easier, you can transform the coordinate system. Use this possibility,
for example, to rotate the coordinate system.
Coordinate transformations only apply in the actual program.
You can define the following transformations:
● Offset
● Rotation
● Scaling
● Mirroring
● Rotation C axis
You can select between a new or an additive coordinate transformation.
In the case of a new coordinate transformation, all previously defined coordinate
transformations are deselected. An additive coordinate transformation acts in addition to the
currently selected coordinate transformations.
Note
Transformations with virtual axes
Please note that when selecting TRANSMIT or TRACYL offsets, scaling and mirroring, the
real Y
axis is not transferred into the virtual Y axis.
Offsets, scalings and mirroring of the virtual Y axis are deleted for TRAFOOF.
Procedure for work offset, offset, rotation, scaling, mirroring or rotation C axis.
1.
The ShopTurn program has been created and you are in the editor.
2.
Press the "Various" and "Transformation" softkeys.
3.
Press the "Work offsets” softkey.
The "Work offsets" input window opens.
- OR -
Press the "Offset" softkey.
The "Offset" input window opens.
- OR -
Press the "Rotation" softkey.
The "Rotate" input window opens.
- OR -

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English