Siemens SINUMERIK 828D User Manual

Simulating machining
6.2 Simulation before machining of the workpiece
Turning
200 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
6.2
Simulation before machining of the workpiece
Before machining the workpiece on the machine, you have the option of performing a quick
run-through in order to graphically display how the program will be executed. This provides a
simple way of checking the result of the programming.
Feedrate override
The rotary switch (override) on the control panel only influences the functions of the
"Machine" operating area.
Press the "Program control" softkey to change the simulation feedrate. You can select the
simulation feedrate in the range of 0 - 120%.
See also
Changing the feedrate (Page 208)
Simulating the program block by block (Page 209)
Procedure
1.
Select the "Program m
anager" operating area.
2.
Select the storage location and position the cursor on the program to be
simulated.
3.
Press the "Input" or "Cursor right" key.
- OR -
Double
-click the required program.
The selected program is opened in the "Program" operating area in the
editor.
4.
Press the "Simulation" softkey.
The program execution is displayed graphically on t
he screen. The ma-
chine axes do not move.
5.
Press the "Stop" softkey if you wish to stop t
he simulation.
- OR -
Press the "Reset" softkey to cancel the simulation.
6.
Press the "Start" softkey to restart or continue the simulation.

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English