Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
881
Service Planner (828D only)
Performing and monitoring maintenance tasks
With the "Service Planner", maintenance tasks have been set up that have to be performed
at certain intervals (e.g. top up oil, change coolant).
A list is displayed of all the maintenance tasks that have been set up together with the time
remaining until the end of the specified maintenance interval.
The current status can be seen in the status display.
Messages and alarms indicate when a task has to be performed.
Acknowledging a maintenance task
Acknowledge the message when a maintenance task has been completed.
Note
Protection level
You require protection level 2 (
service) to acknowledge completed maintenance tasks.
Position of the maintenance task in the PLC interface.
Name of the maintenance task.
Maximum time until next servicing in hours.
Time until the interval expires in hours.
Status
Display of the current status of a maintenance task.
The maintenance task has been started.
The maintenance task is completed.
The maintenance task is deactivated.
To Next Page
Loading...
Need help?
General
