Siemens SINUMERIK 828D User Manual

Programming technology functions (cycles)
9.4 Milling
Turning
444 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter
Description
Value
Can be set in SD
PL (only for G
code)
Machining plane
Defined in MD
52005
SC (only for G
code)
Safety clearance 1 mm x
Reference point Position of the reference point: Center
Machining
position
Mill rectangular pocket at the programmed position (X0, Y0,
Z0).
Single posi-
tion
α0
Angle of rotation
0°
Solid machining The rectangular pocket is milled from the solid material -
(only for roughing)
Complete
machining
Machine manufacturer
Please refer to the machine manufacturer's specifications.
9.4.3
Circular pocket (POCKET4)
Function
You can use the "Circular pocket" cycle to mill circular pockets on the face or peripheral
surface.
The following machining variants are available:
● Mill circular pocket from solid material.
● Predrill circular pocket in the center first if, for example, the milling cutter does not cut in
the center (program the drilling, circular pocket and position program blocks in
succession).
For milling with the "Circular pocket" function two methods are available: the plane-by-plane
method and the helical method.
Clamping the spindle
For ShopTurn, the "Clamp spindle" function can be set up by the machine manufacturer.
Machine manufacturer
Please refer to the machine manufacturer's specifications.

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English