Programming technology functions (cycles)
9.4 Milling
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
461
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
PL (only for G
Machining plane Defined in MD
SC (only for G
code)
Safety clearance 1 mm x
Reference point Position of the reference point: Center
Machining
Mill rectangular spigot at the programmed position (X0, Y0,
Single posi-
Please refer to the machine manufacturer's specifications.
Circular spigot (CYCLE77)
Function
You can mill various circular spigots with the "Circular spigot" function.
In addition to the required circular spigot, you must also define a blank spigot, i.e. the outer
limits of the material. The tool moves at rapid traverse outside this area. The blank spigot
must not overlap adjacent blank spigots and is automatically placed on the finished spigot in
a centered position.
The circular spigot is machined using only one infeed. If you want to machine the spigot
using multiple infeeds, you must program the "Circular spigot" function several times with a
reducing finishing allowance.
For ShopTurn, the "Clamp spindle" function can be set up by the machine manufacturer.
Please refer to the machine manufacturer's specifications.
To Next Page
Loading...
Need help?
General
