Siemens SINUMERIK 828D User Manual

Introduction
2.4 User interface
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
47
2.4.4
T,F,S window
The most important data concerning the current tool, the feedrate (path feed or axis feed in
JOG) and the spindle is displayed in the T, F, S window.
In addition to the "T, F, S" window name, the following information is also displayed:
Display
Meaning
BC (example)
Name of the tool carrier
Turning (example) Name of the active kinematic transformation
Active tool carrier rotated in the plane
Active tool carrier swiveled in space
Tool data
Display
Meaning
T
Tool name
Name of the current tool
Location
Location number of the current tool
D Cutting edge of the current tool
The tool is displayed with the associated tool type symbol corresponding to
the actual coordinate system in the selected cutting edge position.
If the tool is swiveled, then this is taken into account in the display of the
cutting edge position.
In DIN-ISO mode the H number is displayed instead of the cutting edge
number.
H H number (tool offset data record for DIN-ISO mode)
If there is a valid D number, this is also displayed.
Ø
Diameter of the current tool
R
Radius of the current tool
L Length of the actual tool
Z
Z value of the current tool
X
X value of the current tool

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English