Siemens SINUMERIK 828D User Manual

Multi-channel machining
10.2 Multi-channel support
Turning
652 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
10.2.12.2
Block search and program control
You define a group of channels that belong to one another from the "Settings for Multi-
channel Functionality" window. Here, you specify which channel numbers should be
displayed for a multi-channel view.
This group results in a common behavior for a block search and for program control.
Vertical softkeys for a block search
● The "Block search" and "Search mode" functions act on all channels, which you
configured for the multi-channel view.
● All other vertical softkeys (e.g. "Search text", "Interrupt position", etc.). act on the current
program.
If you selected the single-channel view in the multi-channel function settings, then all of the
actions only act on the actual channel.
Software options
You require the "programSYNC" option for the multi
-channel block
search and
the multi-channel program control in the multi-channel editor.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Procedure
1.
Press the "Bl
ock search" softkey.
Press the "Search mode" softkey.
The "Search Mode" window is displ
ayed.
2.
Select the required mode for the channel group.
3.
Press the "OK" softkey to c
onfirm the setting.
4.
Press the "Search text" softkey if you wish to enter the search
tar
get using a text.
-
OR -
Press the "Interrupt position" softkey if you wish to search
for the
search target using a program interrupt.
- OR -
Press the "Search pointer" sof
tkey if you wish to enter a search
target that you cannot enter using the editor (e.g. no interrupt
position, search target is located in the subprogram) and enter
the program path.

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English