Siemens SINUMERIK 828D User Manual

Multi-channel machining
10.2 Multi-channel support
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
653
5.
Press the "Start search" softkey.
The search starts.
All channels of the group are started corresponding to the search
mode that has been set.
During the bloc
k search, the search states are displayed in a
message window (e.g. "Block search running").
You receive a message if the search target has been reached
-
or
an error message if the search target was not found.
Note
Search target via "Search pointer"
The "Search Pointer" window is displayed
- as usual - over the complete lower part of the
screen. The upper contents of the window remain multi
-channel.
The actual channel is displayed in the title bar of the "Search Pointer" window.
The "Delete search po
inter" also only acts on this channel.
Note
Search target via "Search text"
If, for a block search, you approach the program position using "Search text", please note
that a search is only made in the selected channel column.

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English