Siemens SINUMERIK 828D User Manual

Tool management
12.8 Magazine
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
705
4.
Press the "OK" softkey to relocate the tool to the recommended mag
a-
zine location.
- OR -
Enter the required magazine number in the "...magazine" field and the
required magazine location number in "Location" field.
Press the "OK" softkey.
The tool is relocated to the specified magazine location.
Several magazines
If you have set up several magazines, then the "...relocate from magazine... location... to..."
window appears after pressing the "Relocate" softkey.
Select the desired magazine and location, and confirm your selection with "OK" to load the
tool.
12.8.3
Unload/load/relocate all tools
You have the option of unloading all tools from the magazine list, loading all tools to the
magazine or relocating tools simultaneously.
Preconditions
The following requirements must be satisfied so that the "Unload all", "Load all" or "Relocate
all" softkey is displayed and available:
● Magazine management is set up
● There is no tool in the buffer / in the spindle
Machine manufacturer
Please refer to the machine manufacturer's
specifications.
Procedure
1.
The magazine list is opened.
2.
Press the "Unload all" softkey.
- OR -
Press the "Load all" softkey.
- OR -

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English