Siemens SINUMERIK 828D User Manual

Tool management
12.5 Tool list
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
695
6.
Press the "OK" softkey.
The tool is added to the tool list with the specified name. If the cu
rsor is
located on an empt
y magazine location in the tool list, then the tool is
loaded to this magazine location.
The tool creation sequence can be defined differently.
Unloading a tool in a file
1.
The tool list is opened.
2.
Place the cursor on the tool that you would like to unload from th
e mag-
azine and press the "Unload" and "In file" softkeys.
3.
Navigate to the required dire
ctory and press the "OK" softkey.
4.
Enter the required file name in the "Name" field and
press the "OK"
softkey.
The field is pre
-assigned with the tool names.
The tool is unloaded and the data of the tool are written to the file.
According to the corresponding setting, after being read out, the unloaded tool is deleted
from the NC memory.
Deleting a tool in a file
1.
The tool list is opened.
2.
Position the cursor on the tool that you wish to delete.
3.
Press the "Delete tool" and "In file" softkeys.
3.
Navigate to the required directory and press the "OK" softkey.
4.
Enter the required file name in the "Name" field and press the "OK"
softkey.
The field is pre
-assigned with the tool names.
The tool is unloaded and the data of the tool are written to the file. The
tool is then deleted from the NC memory.

Siemens SINUMERIK 828D Specifications

General

Brand	Siemens
Model	SINUMERIK 828D
Category	Control Systems
Language	English