Tool management
12.15 Working with multitool
Turning
728 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Select the "Parameter" operating area.
Press the "Tool wear" softkey.
Position the cursor at the multitool that is disabled and which you
would like to reactivate.
or on the tool that you would like to reactivate
Press the "Reactivate" softkey
.
The value entered as the setpoint is entered as the new tool life
or workpiece count.
The tool and the multitool are then no longer disabled (the disable
is withdrawn).
Reactivating and positioning
When the "Reactivate with positioning" function is configured, then also the magazine
location at which the selected multitool is located, is positioned to the loading point. You can
exchange the multitool.
Reactivation of all monitoring types
When the "Reactivation of all monitoring types" function is configured, all the monitoring
types set in the NC for a tool are reset during reactivation.
Please refer to the machine manufacturer's specifications.
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
To Next Page
Loading...
Need help?
General
