FEATURES
1-11
Resetting
The traction control system may be disabled in the following conditions:
• Either the front wheel or rear wheel comes off the ground while riding
• Excessive rear wheel spinning
If the traction control system has been disabled, both the traction control system indicator/warning
light and the engine trouble warning light come on.
To reset the traction control system:
Turn the key to “OFF”. Wait at least one second, then turn the key back to “ON”. The traction control
system indicator/warning light should go off and the system will be enabled. The engine trouble
warning light should go off after the motorcycle reaches at least 20 km/h (12 mi/h). If the traction
control system indicator/warning light and/or engine trouble warning light still remain on after reset-
ting, check the fuel injection system (Refer to “FUEL INJECTION SYSTEM” on page 8-33).
ECA1KB8101
• Keep any type of magnets (including magnetic pick-up tools, magnetic screwdrivers, etc.)
away from the front and rear speed sensor or front speed sensor rotor; otherwise, the sen-
sors or rotor may be damaged, resulting in improper performance of the traction control
system.
• Be careful not to damage the sensors or rotor.
1. Traction control system switch
2. Traction control system mode display
To Next Page
Loading...
Need help?
General
