P1086708-001 ZXP Series 9 Card Printer Service Manual 7
Setup
Unpacking the Printer with a Laminator
Unpacking the Printer with a Laminator
Important • Save all the packing material and the shipping carton in case the printer needs to be
moved or shipped. If the original packing material is lost or damaged, a replacement shipping kit can
be ordered from Zebra.
Make sure the following items are included with the printer:
îš… Setup Guide (to be used as a reference poster)
îš… User CD
îš… Product Registration Card
îš… Printer Test Cards
îš… Upper Laminate Cassette (for single- and double sided printers)
îš… Lower Laminate Cassette (for double-sided printers)
îš… Input Hopper with stack of 100 cards
îš… Output Hopper
îš… Cleaning Cartridge
îš… Cleaning Roller
îš… USB Cable
îš… Power Cable
If any items are missing, please contact your Zebra representative.
Place the printer in a location that meets the following requirements:
y A reasonably dust- and dirt-free environment.
y Flat surface at least 38 x 28 inches (965 x 711 mm) deep that can support the weight of the
printer; additional space preferred. Allow a 4-inch minimum clearance on all sides.
y Vertical clearance at least 32 inches (813 mm).
y Temperature within the range of 59–95°F (15–35°C).
y Relative Humidity 20–80% inclusive, non-condensing.
y AC power accessible.
To Next Page
Loading...
Need help?
General
