234 ZXP Series 9 Card Printer Service Manual P1086708-001
Replacement Procedures for the Printer
Procedures: Front Bezel
Front Bezel
For replacement, use Kit Enclosure with Panel 105936G-371. Contact Zebra Customer Service at
+01 877-275-9327 for ordering information.
Step 1. With a TORX T10 driver, remove the two screws (circled below) holding the front
bezel in place.
Step 2. Set the printer on its left side.
Step 3. Lift the locking tab and slide a card under the lip of the front bezel to release. Leave
the card in place and release the other locking tab. Do not use a screwdriver as
damage may occur to the main PCBA.
Step 4. Remove the front bezel.
To Next Page
Loading...
Need help?
General
