D-Link DWL-2600AP User Manual

Configuring IGMP Snooping
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 215
D-Link UWS User Manual
Interface Configuration
Use the IGMP Snooping Interface Configuration page to configure IGMP snooping settings on specific
interfaces.
To access the IGMP Snooping Interface Configuration page, click LAN > L2 Features> IGMP Snooping >
Interface Configuration in the navigation tree.
Figure 120: IGMP Snooping Interface Configuration
• If you make any changes on the page, click Submit to apply the new settings to the switch.
Table 104: IGMP Snooping Interface Configuration Fields
Field Description
Interface Select the physical or LAG interfaces to configure.
Admin Mode Select the interface mode for the selected interface for IGMP Snooping for the
switch from the pulldown menu. The default is disable.
Group Membership Interval Specify the amount of time you want the switch to wait for a report for a
particular group on a particular interface before it deletes that interface from
the group. The valid range is from (2 to 3600) seconds. The default is 260
seconds.
Max Response Time Specify the amount of time you want the switch to wait after sending a query
on an interface because it did not receive a report for a particular group on
that interface. Enter a value greater or equal to 1 and less than the Group
Membership Interval in seconds. The default is 10 seconds. The configured
value must be less than the Group Membership Interval.
Multicast Router Present
Expiration Time
Specify the amount of time you want the switch to wait to receive a query on
an interface before removing it from the list of interfaces with multicast
routers attached. Enter a value between 0 and 3600 seconds. The default is 0
seconds. A value of zero indicates an infinite timeout; i.e., no expiration.
Fast Leave Admin Mode Select the Fast Leave mode for the a particular interface from the pulldown
menu. The default is Disable. Enabling Fast Leave mode allows the switch to
immediately remove the Layer 2 LAN interface from its forwarding table entry
upon receiving an IGMP leave message for that multicast group without first
sending out MAC-based general queries to the interface.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm