AP Management
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 588
D-Link UWS User Manual
Command Buttons
The page includes the following button:
• Refresh—Updates the page with the latest information.
Adjusting the Channel and Power
Changes you make to the channel and power are runtime changes only. If you change the channel or power
settings, the new settings are lost if the AP or switch is reset.
Figure 376: Managed AP Debug
The fields in Table 345 on page 589 appear when you click the current channel or power setting for an AP on
the Managed AP Advanced page.
Confirm Password Since the password is encrypted, you must retype the password to confirm the
password.
Enable Debug Select or clear the Enable check box to enable or disable debugging.
Once once you Telnet to the AP, you get an AP interface login prompt. The user name
is admin. Enter the password you set in the previous field. The default password is
admin if you did not specify a new password. From the AP CLI, you can also access
the standard Linux prompt by typing the '!' character.
You can issue the following debug commands at the Linux OS prompt:
•
get management: Display management interface information
•
get managed-ap: Display managed AP information
You can issue the following debug commands at the Linux OS prompt:
•
ifconfig: display all interfaces.
•
cat /proc/meminfo: View memory utilization
Table 344: Managed AP Debug
Field Description
To Next Page
Need help?
General
Weight and Dimensions
