D-Link DWL-2600AP User Manual

MAC Access Control Lists
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 364
D-Link UWS User Manual
IP ACL Rule Summary
Use the IP ACL Rule Summary page to view a summary of the IP ACLs that have been configured on the switch.
To access the page, click LAN > Monitoring > Access Control Lists > IP Access Control Lists > Summary.
Figure 243: IP ACL Rule Summary
MAC Access Control Lists
A MAC ACL consists of a set of rules which are matched sequentially against a packet. When a packet meets
the match criteria of a rule, the specified rule action (Permit/Deny) is taken and the additional rules are not
checked for a match. On this menu the interfaces to which an MAC ACL applies must be specified. Rules for
the MAC ACL are specified/created using the MAC ACL Rule Configuration menu.
To configure a MAC ACL:
1. Use the “MAC ACL Configuration” page to define the ACL type and assign an ID to it.
2. Use the “MAC ACL Rule Configuration” page to create rules for the ACL.
3. Use the “ACL Interface Configuration” to assign the ACL by its ID number to a port or VLAN.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm