D-Link DWL-2600AP User Manual

Network DHCP Client Options
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 75
D-Link UWS User Manual
• If you change any of the network connection parameters, click Submit to apply the changes to the system.
If you want the switch to retain the new values across a power cycle, you must perform a save.
Network DHCP Client Options
Use the fields on this page to enable and configure vendor class identifier information that the DHCP client on
the switch sends to the DHCP server when it requests a lease.
To access this page, click LAN > Administration > Network DHCP Client Options.
Locally Administered MAC
Address
You can optionally configure a locally administered MAC address for in-band
connectivity instead of using the burned-in universally administered MAC
address. In addition to entering an address in this field, you must also set the
MAC address type to locally administered. Enter the address as twelve
hexadecimal digits (6 bytes) with a colon between each byte. Bit 1 of byte 0
must be set to a 1 and bit 0 to a 0; i.e., byte 0 must have a value between x'40'
and x'7F'.
MAC Address Type Select the MAC address to use for in-band connectivity. The factory default is
to use the burned-in MAC address.
• Burned-In: Use the factory default MAC address.
• Locally Administered: Use the MAC address you entered in the Locally
Administered MAC Address field.
Management VLAN ID Specifies the management VLAN ID of the switch. The range is 1-3965. The
management VLAN is used for management of the switch. This field is
configurable for administrative users and read-only for other users.
Web Mode Controls whether the switch user interface can be accessed from a Web
browser. The factory default is enabled.
• Enable: Permits Web-based management of the switch.
• Disable: Prohibits Web-based management of the switch. If the Web
mode is disabled, you must manage the switch by using SNMP or the CLI.
Java Mode Controls whether to display the Java applet that displays a picture of the
switch at the top right of the screen. The factory default is enabled:
• Enable: Permits the applet to display. The Java applet lets click on the
picture of the switch to select configuration screens instead of using the
navigation tree at the left side of the screen.
• Disable: Does not allow the Java applet to display. The applet is replaced
by a blank area.
Table 10: Network Connectivity Fields (Cont.)
Field Description

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm