Captive Portal Configuration
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 385
D-Link UWS User Manual
The following table describes the global CP fields you can view or configure.
Table 223: Captive Portal Global Configuration
Field Description
Enable Captive
Portal
Select the check box to enable the CP feature on the switch. Clear the check box to
disable the captive portal feature.
CP Global
Operational Status
Shows whether the CP feature is enabled.
CP Global Disable
Reason
If CP is disabled, this field displays the reason, which can be one of the following:
• None
• Administratively Disabled
• No IPv4 Address
• Routing Enabled, but no IPv4 routing interface
Additional HTTP
Port
HTTP traffic uses port 80, but you can configure an additional port for HTTP traffic. Enter
a port number between 0-65535 (excluding ports 80, 443, and the configured switch
management secure port).
Additional HTTP
Secure Port
HTTP traffic over SSL (HTTPS) uses port 443, but you can configure an additional port for
HTTPS traffic. Enter a port number between 0-65535 (excluding ports 80, 443, and the
configured switch management secure port).
Peer Switch
Statistics Reporting
Interval
When clustering is supported on the switch, enter a value to determine how often the
switch sends its authenticated client statistics to the Cluster Controller. The interval is in
seconds. Enter a value of 0 to prevent the switch from reporting the statistics.
Authentication
Timeout
To access the network through a portal, the wireless client must first enter
authentication information on an authentication Web page. Enter the number of
seconds to keep the authentication session open with the client. When the timeout
expires, the switch disconnects any active TCP or SSL connection with the client.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
