Monitoring Status and Statistics
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 490
D-Link UWS User Manual
Figure 318: RF Scan
To view additional information about a detected AP, click the MAC address of the AP.
Table 287 describes the fields on the Rogue/RF Scan page.
Table 287: Access Point RF Scan Status
Field Description
MAC Address The Ethernet MAC address of the detected AP. This could be a physical radio interface or
VAP MAC. For D-Link APs this is always a VAP MAC address.
SSID Service Set ID of the network, which is broadcast in the detected beacon frame.
Physical Mode Indicates the 802.11 mode being used on the AP.
Channel Transmit channel of the AP.
Status Indicates the managed status of the AP, whether this is a valid AP known to the switch or
a Rogue on the network. The valid values are:
• Managed: The neighbor AP is managed by the wireless system.
• Standalone: The AP is managed in standalone mode and configured as a valid AP entry
(local or RADIUS).
• Rogue: The AP is classified as a threat by one of the threat detection algorithms.
• Unknown: The AP is detected in the network but is not classified as a threat by the
threat detection algorithms.
Age Time since this AP was last detected in an RF scan.
Status entries for the RF Scan Status page are collected at a point in time and eventually
age out. The age value for each entry shows how long ago the switch recorded the entry.
You can configure the age out time for status entries on the WLAN > Advanced
Configuration > Global page. You can also manually delete status entries.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
