D-Link DWL-2600AP User Manual

Configuring RIP
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 307
D-Link UWS User Manual
Configuring the RIP Interface
1. Open the RIP Interface Configuration page.
2. Specify the interface for which data is to be configured.
3. Enter data into the fields as needed.
4. To change the Authentication Type, click Configure Authentication to configure different Authentication
Types.
The page refreshes and displays the RIP Interface Authentication Configuration page.
Figure 196: RIP Interface Authentication Configuration
5. Select the type of authentication to use.
If you select Simple or Encrypt as the authentication, the screen refreshes, and additional fields display.
Enter the required information into the new fields.
6. Click Submit to apply the changes to the system and return to the RIP Interface Configuration page.
7. To cancel the authentication configuration and return to the RIP Interface Configuration page, click
Cancel.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm