Card Configuration
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 69
D-Link UWS User Manual
PoE Configuration
Use the PoE Configuration page to configure the Power over Ethernet (PoE) features.
To access the PoE Configuration page, click LAN > Administration > PoE Configuration in the navigation menu.
The following figure shows the fields that display.
Figure 12: PoE Configuration
Table 7: PoE Configuration Fields
Field Description
System Usage Threshold Sets threshold level at which a trap is sent if the total power consumed is
greater than or equal to the specified percentage of total power available.
Power Management Mode Sets the PoE switch in the following power management modes. The options
are as follows:
• Static: In this mode the power initially requested by the powered device is
reserved for the port alone. The reserved power is also equal to the power
limit of the port. Thus the total power available for the prospective
powered devices is less than the actual available power. This configuration
is useful in cases when the powered devices can draw variable power and
also be assured that power is always available for this purpose.
• Dynamic: In this mode there is no power reservation for a port. Thus the
total power available for the prospective powered devices is more in this
configuration. This configuration is useful when there are many powered
devices and less power available with the PoE switch.
Slot/Port Select the slot and port with the information to configure.
Admin Mode Enables or disables the ability of the port to deliver power.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
