Configuring RIP
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 308
D-Link UWS User Manual
RIP Interface Summary
Use the RIP Interface Summary page to display RIP configuration status on an interface.
To display the page, click LAN > Monitoring > L3 Status > RIP > Interface Summary in the navigation tree.
Figure 197: RIP Interface Summary
• Click Refresh to update the information on the screen.
Table 179: RIP Interface Summary Fields
Field Description
Interface The interface, such as the routing-enabled VLAN on which RIP is enabled.
IP Address The IP Address of the router interface.
Send Version Specifies the RIP version to which RIP control packets sent from the interface
conform. The default is RIP-2. Possible values are:
• RIP-1: RIP version 1 packets are sent using broadcast.
• RIP-1c: RIP version 1 compatibility mode. RIP version 2 formatted packets
are transmitted using broadcast.
• RIP-2: RIP version 2 packets are sent using multicast.
• None: RIP control packets are not transmitted.
Receive Version Specifies which RIP version control packets are accepted by the interface. The
default is Both. Possible values are:
• RIP-1: only RIP version 1 formatted packets are received.
• RIP-2: only RIP version 2 formatted packets are received.
• Both: packets are received in either format.
• None: no RIP control packets are received.
RIP Admin Mode Specifies whether RIP is Enabled or Disabled on the interface.
Link State Specifies whether the RIP interface is up or down.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
