D-Link DWL-2600AP User Manual

Outbound Telnet Client Configuration
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 94
D-Link UWS User Manual
Outbound Telnet Client Configuration
The outbound telnet feature is not available on all platforms.
Use the outbound telnet client settings to control the telnet sessions that originate from the switch and
connect to a remote system.
To access the Outbound Telnet Client Configuration page, click LAN > Administration > Outbound Telnet
Client Configuration in the navigation menu.
Figure 27: Outbound Telnet
• If you change any data, click Submit to apply the changes to the system. If you want the switch to retain
the new values across a power cycle, you must perform a save.
Table 22: Outbound Telnet Fields
Field Description
Admin Mode Specifies whether the Outbound Telnet service is Enabled or Disabled. The
default value is Enabled.
• Enable: Users can initiate outbound telnet sessions from the switch CLI.
• Disable: No outbound telnet sessions can originate from the switch.
Maximum Sessions Specifies the maximum number of Outbound Telnet Sessions allowed. The
default value is 5. The valid range is 0 to 5 sessions.
Session Timeout Specifies the Outbound Telnet login inactivity timeout. The default value is 5.
The valid range is 1 to 160 minutes.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm