D-Link DWL-2600AP User Manual

Basic Setup
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 549
D-Link UWS User Manual
Radio Configuration
In order to accommodate a broad range of wireless clients and wireless network requirements, the
DWL-8600AP and DWL-6600AP support two radios. Radio 1 can broadcast in one of the following modes:
• IEEE 802.11a mode
• IEEE 802.11a and IEEE 802.11n modes
• 5 GHz IEEE 802.11n mode
Radio 2 can broadcast in one of the following modes:
• IEEE 802.11b and IEEE 802.11g modes
• IEEE 802.11b, IEEE 802.11g, and IEEE 802.11n modes
• 2.4 GHz IEEE 802.11n mode
The DWL-3600AP supports one radio that can broadcast in one of the following modes:
• IEEE 802.11b and IEEE 802.11g modes
• IEEE 802.11b, IEEE 802.11g, and IEEE 802.11n modes
• 2.4 GHz IEEE 802.11n mode
You configure the default radio settings from the WLAN > Basic Setup > Radio tab, which the following figure
shows.
Figure 359: Radio Settings
The DWL-3600AP is a single-radio AP. Any settings you configure for Radio 1 (802.11a/n) are not
applied to the DWL-3600AP.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm