Managing LLDP
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 260
D-Link UWS User Manual
Interface Configuration
Use the LLDP Interface Configuration page to specify LLDP parameters that are applied to a specific interface.
To display the LLDP Interface Configuration page, click LAN > L2 FeaturesLLDPInterface Configuration in
the navigation tree.
Figure 159: LLDP Interface Configuration
• If you make any changes to the page, click Submit to apply the new settings to the system.
Table 142: LLDP Interface Configuration Fields
Field Description
Interface Specifies the port to be affected by these parameters.
Transmit Enables or disables the transmission of LLDP protocol data units (PDUs). The
default is disabled.
Receive Enables or disables the ability of the port to receive LLDP PDUs. The default is
disabled.
Notify When notifications are enabled, LLDP interacts with the Trap Manager to
notify subscribers of remote data change statistics. The default is disabled.
Transmit Management
Information
Select the check box to enable the transmission of management address
instance. Clear the check box to disable management information
transmission. The default is disabled.
Optional TLV(s) Select each check box next to the type-length value (TLV) information to
transmit. Choices include:
• System Name. To include system name TLV in LLDP frames. To configure
the System Name, see “System Description” on page 63.
• System Description. To include system description TLV in LLDP frames.
• System Capabilities. To include system capability TLV in LLDP frames.
• Port Description. To include port description TLV in LLDP frames. To
configure the Port Description, see “Port Description” on page 113
To Next Page
Loading...
Need help?
General
Weight and Dimensions
