D-Link DWL-2600AP User Manual

Monitoring Status and Statistics
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 465
D-Link UWS User Manual
Monitoring AP Status
The following figure shows the Managed Access Point Status page with two managed APs.
Figure 314: Managed AP Status
The following tabs are available from the Managed AP Status page:
• Summary: Lists the APs managed by the switch and provides summary information about them.
• Detail: Shows detailed status information collected from the AP.
• Radio Summary: Shows the channel, transmit power, and number of associated wireless clients for all
managed APs.
• Radio Detail: Shows detailed status for a radio interface. Use the radio button to navigate between the
two radio interfaces.
• Neighbor APs: Shows the neighbor APs that the specified AP has discovered through periodic RF scans on
the selected radio interface.
• Neighbor Clients: Shows information about wireless clients associated with an AP or detected by the AP
radio.
• VAP: Shows summary information about the virtual access points (VAPs) for the selected AP and radio
interface on the APs that the switch manages.
• Distributed Tunneling: Shows information about the L2 tunnels currently in use on the AP.
The following table provides summary information about the APs that the switch manages. If the switch is the
Cluster Controller, the page provides information about the APs managed by all switches in the cluster.
Table 269: Managed Access Point Status
Field Description
MAC Address The Ethernet address of the DWS-4000 Series switch- managed AP. If the MAC address
of the AP is followed by an asterisk (*), it is managed by a peer switch.
Location A location description for the AP. This is the value configured in the valid AP database
(either locally or on the RADIUS server).
Switch Port The physical port (in the slot/port format) on the switch that the AP is connected to
either directly or indirectly in the same L3 domain. If the AP is beyond the L3 network
boundary, then ‘Unknown’ is displayed.

D-Link DWL-2600AP Specifications

General

Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Maximum data transfer rate	300 Mbit/s
Internal	Yes
LED indicators	Power, Stand-by, Status, WAN, WLAN
WAN connection	Ethernet (RJ-45)
Ethernet LAN (RJ-45) ports	1
Security algorithms	WEP, WPA, WPA2
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Width	160 mm
Height	45 mm
Weight	240 g
Dimensions (WxDxH)	160 x 160 x 45 mm