Configuring Advanced Settings
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 601
D-Link UWS User Manual
Device Location Configuration
The Device Location feature can help you physically locate APs and other WLAN devices in different buildings
and on multiple floors of a building. You can configure the information manually or use the WLAN Visualization
tool to place the managed APs on floor plans, and then import the Building Floor objects with their associated
APs from the WLAN Visualization tool to the switch. The location computation is performed by the Cluster
Controller switch. You can use the WLAN Visualization tool to trigger the location search and to display the
computed probability map.
Use the Device Location Configuration page to configure settings for the Device Location feature.
Figure 382: Device Location Configuration
The following table shows the fields on the Device Location Configuration page.
Command Buttons
The page includes the following buttons:
• Submit—Updates the switch with the values you enter. To retain the new values across a power cycle,
you must perform a save (Tool > Save Changes).
• Refresh—Updates the page with the latest information.
Table 351: Device Location Configuration
Field Description
Measurement System Specify the units of measure to use for device location:
• Metric — Measures distances in meters
• English — Measures distances in feet
RF Scan Mode Specify whether the switch computes the location of a device from RF-
Scan reports for the device. When this mode is enabled the location is
stored in the Device Triangulation table.
RF Scan Interval Specify the number of seconds between the iterations of the
triangulation table device location protocol.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
