Configuring Spanning Tree Protocol
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 244
D-Link UWS User Manual
• If you make any configuration changes, click Submit to apply the new settings to the switch.
• Click Refresh to update the information on the screen with the most current data.
Table 132: Spanning Tree Switch Configuration/Status Fields
Field Description
Spanning Tree Admin Mode Enables or disables on the switch.
Force Protocol Version Specifies the Force Protocol Version parameter for the switch:
• IEEE 802.1D: Spanning Tree Protocol ()
• IEEE 802.1w: Rapid Spanning Tree Protocol (R)
• IEEE 802.1s: Multiple Spanning Tree Protocol (M)
Configuration Name Name used to identify the configuration currently being used. It may be up to
32 alphanumeric characters.
Configuration Revision Level Number used to identify the configuration currently being used. The values
allowed are between 0 and 65535. The default value is 0.
Configuration Digest Key Number used to identify the configuration currently being used. The digest
key is generated based on the association of VLANs to different instances. To
ensure the digest key is same on two different switches, the mapping of VLAN-
to-instance must be the same.
MST ID Table consisting of the MST instances (including the CST) and the
corresponding VLAN IDs associated with each of them.
VID This table consists of the VLAN identifier (VID) and the corresponding filtering
identifier (FID) associated with each VID.
FID Table consisting of the FIDs and the corresponding VLAN IDs associated with
each of them.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
