AP Management
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 593
D-Link UWS User Manual
Command Buttons
The page includes the following buttons:
• Delete—Remove the AP from the AP provisioning list.
• Provision the AP—Initiate provisioning for the AP. After the AP is provisioned, it should become managed
by the switch with the configured Primary IP Address and appear in the AP provisioning database as a
managed AP.
• Submit—Updates the switch with the values you enter. To retain the new values across a power cycle,
you must perform a save (Tool > Save Changes).
• Refresh—Updates the page with the latest information.
AP Certificate and Profile Transmit
Status
Status of the last AP profile and X.509 Certificate distribution to the
Primary and Backup switches. This status is changed as a result of the
AP provisioning command. The X.509 certificate is sent to the primary
and backup switches only if mutual authentication is enabled.
The status is one of the following:
• Not Started—No information for this AP has been sent to the
primary and backup switch.
• Success—AP Profile and X.509 Certificate is sent to Primary and
Backup Switches.
• Failed—The primary or backup switch wasn't in the cluster when
this switch attempted to send the information.
New Primary IP Address Enter the IP address of the switch that should manage the AP.
New Backup IP Address Enter the IP address of switch to which the AP should try to connect if
it is unable to connect to the primary switch.
Profile Select the AP profile that the AP should use.
Table 347: AP Provisioning Status (Cont.)
Field Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
