242 Using the RACADM Command Line Interface
CAUTION: The latest iDRAC6 firmware supports only the latest RACADM version.
You may encounter errors if you use an older version of RACADM to query iDRAC6
with the latest firmware. Install the RACADM version shipped with your latest
Dellâ„¢ OpenManageâ„¢ DVD media.
RACADM Subcommands
Table 15-1 provides a description of each RACADM subcommand that you
can run in RACADM. For a detailed listing of RACADM subcommands
including syntax and valid entries, see "RACADM Subcommand Overview."
Table 15-1. RACADM Subcommands
Command Description
arp Displays the contents of the ARP table. ARP table entries
cannot be added or deleted.
clearasrscreen Clears the last crash (ASR) screen.
coredump Displays the last iDRAC6 core dump.
coredumpdelete Deletes the core dump stored in iDRAC6.
clrraclog Clears iDRAC6 log. After clearing, a single entry is made to
indicate the user and time that the log was cleared.
clrsel Clears the managed server’s System Event Log entries.
config Configures iDRAC6.
fwupdate Updates iDRAC6 firmware.
getconfig Displays the current iDRAC6 configuration properties.
getniccfg Displays the current IP configuration for the controller.
getraclog Displays iDRAC6 log.
getractime Displays iDRAC6 time.
getsel Displays SEL entries.
getssninfo Displays information about active sessions.
getsvctag Displays the service tag.
getsysinfo Displays information about iDRAC6 and the managed server,
including IP configuration, hardware model, firmware
versions, and operating system information.
To Next Page
Loading...
Need help?
General
