276 Using iDRAC6 Enterprise SM-CLP Command Line Interface
Navigating the MAP Address Space
NOTE: The slash (/) and backslash (\) are interchangeable in SM-CLP address
paths. However, a backslash at the end of a command line continues the command
on the next line and is ignored when the command is parsed.
Objects that can be managed with SM-CLP are represented by targets
arranged in a hierarchical space called the Manageability Access Point (MAP)
address space. An address path specifies the path from the root of the address
space to an object in the address space.
The root target is represented by a slash (/) or a backslash (\). It is the default
starting point when you log in to iDRAC6. Navigate down from the root using
the cd verb.
For example to navigate to the third record in the System Event Log (SEL),
enter the following command:
->cd /admin1/system1/logs1/log1/record3
Enter the cd verb with no target to find your current location in the address
space. The .. and . abbreviations work as they do in Windows and Linux:
.. refers to the parent level and . refers to the current level.
Targets
For a list of targets available through the SM-CLP, see the SM–CLP mapping
document available on the Dell Enterprise Technology Center at
www.delltechcenter.com.
Using the Show Verb
To learn more about a target use the show verb. This verb displays the
target’s properties, sub-targets, associations, and a list of the SM-CLP verbs
that are allowed at that location.
Using the -display Option
The show –display option allows you to limit the output of the command to
one or more of properties, targets, associations, and verbs. For example, to
display just the properties and targets at the current location, use the
following command:
To Next Page
Loading...
Need help?
General
