Dell IDRAC6 User Manual

RACADM Subcommand Overview 335
RACADM Subcommand Overview
This section provides descriptions of the subcommands that are available in
the RACADM command line interface.
CAUTION: The latest iDRAC6 firmware supports only the latest RACADM version.
You may encounter errors if you use an older version of RACADM to query iDRAC6
with the latest firmware. Install the RACADM version shipped with your latest
Dell™ OpenManage™ DVD media.
CAUTION: Some RACADM commands described in this chapter are not available
with OpenManage™ version 6.1 release. Support will be added in OpenManage
version 6.2 release.
help
Table A-1 describes the help command.
Synopsis
racadm help
racadm help <
subcommand >
Description
The help subcommand lists all of the subcommands that are available when
using the racadm command along with a one-line description. You may also
enter a subcommand after help to get the syntax for a specific subcommand.
Table A-1. Help Command
Command Definition
help Lists all of the subcommands available to use with
racadm and provides a short description for each.

Dell IDRAC6 Specifications

General

Remote Management	Yes
Out-of-band Management	Yes
Remote KVM	Yes
Virtual Console	Yes
Version	6
Interface	Web-based
Features	Remote console, Virtual media
Security	SSL encryption
Protocols Supported	IPMI, SNMP
Authentication	Active Directory
Compatible Hardware	Dell PowerEdge servers (11th generation)
Remote Access	Yes
Alerts and Notifications	Email, SNMP traps
Power Management	Remote power on/off/reset, Power monitoring
Firmware Updates	Remote firmware updates via web interface or command line