Dell IDRAC6 User Manual

94 Configuring iDRAC6 Enterprise Using the Web Interface
Configuring Platform Events
Platform event configuration provides a mechanism for configuring iDRAC6
to perform selected actions on certain event messages. The actions include no
action, reboot system, power cycle system, power off system, and generate an
alert (Platform Event Trap [PET] and/or e-mail).
The filterable platform events are listed in Table 5-8.
.
When a platform event occurs (for example, a Battery Probe Warning),
a system event is generated and recorded in the System Event Log (SEL).
If this event matches a platform event filter (PEF) that is enabled and you
have configured the filter to generate an alert (PET or e-mail), then a PET or
e-mail alert is sent to one or more configured destinations.
Apply Saves any new settings that you made to the Network
Security screen.
Go Back to
Network
Configuration Page
Returns to the Network screen.
Table 5-8. Filterable Platform Events
Index Platform Event
1 Battery Probe Warning
2 Battery Probe Failure
3 Discrete Voltage Probe Failure
4 Temperature Probe Warning
5 Temperature Probe Failure
6 Processor Failure
7 Processor Absent
8 Hardware Log Failure
9 Automatic System Recovery
Table 5-7. Network Security Buttons (continued)
Button Description

Dell IDRAC6 Specifications

General

Remote Management	Yes
Out-of-band Management	Yes
Remote KVM	Yes
Virtual Console	Yes
Version	6
Interface	Web-based
Features	Remote console, Virtual media
Security	SSL encryption
Protocols Supported	IPMI, SNMP
Authentication	Active Directory
Compatible Hardware	Dell PowerEdge servers (11th generation)
Remote Access	Yes
Alerts and Notifications	Email, SNMP traps
Power Management	Remote power on/off/reset, Power monitoring
Firmware Updates	Remote firmware updates via web interface or command line