Dell IDRAC6 User Manual

Using the RACADM Command Line Interface 267
modified. If an index is not present, the first available index is used.
This method allows flexibility when adding indexed entries where you do
not need to make exact index matches between all the RACs being
managed. New users are added to the first available index. A configuration
file that parses and runs correctly on one iDRAC6 may not run correctly on
another if all indexes are full and you must add a new user.
Modifying iDRAC6 IP Address in a Configuration File
When you modify iDRAC6 IP address in the configuration file, remove all
unnecessary <variable>=<value> entries. Only the actual variable group’s
label with "[" and "]" remains, including the two <variable>=<value>
entries pertaining to the IP address change.
For example:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.10.110
cfgNicGateway=10.35.10.1
This file will be updated as follows:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.9.143
# comment, the rest of this line is ignored
cfgNicGateway=10.35.9.1

Dell IDRAC6 Specifications

General

Remote Management	Yes
Out-of-band Management	Yes
Remote KVM	Yes
Virtual Console	Yes
Version	6
Interface	Web-based
Features	Remote console, Virtual media
Security	SSL encryption
Protocols Supported	IPMI, SNMP
Authentication	Active Directory
Compatible Hardware	Dell PowerEdge servers (11th generation)
Remote Access	Yes
Alerts and Notifications	Email, SNMP traps
Power Management	Remote power on/off/reset, Power monitoring
Firmware Updates	Remote firmware updates via web interface or command line