Dell IDRAC6 User Manual

RACADM Subcommand Overview 367
Input
Table A-37 describes the testtrap subcommand options.
Supported Interfaces
•Local RACADM
• Remote RACADM
• telnet/ssh RACADM
vmdisconnect
Synopsis
racadm vmdisconnect
Description
The vmdisconnect subcommand allows a user to disconnect another user's
virtual media session. Once disconnected, the Web interface will reflect the
correct connection status.
Table A-36. cfg e-mail Alert Commands
Action Command
Enable the alert racadm config -g cfgIpmiPet -o
cfgIpmiPetAlertEnable -i 1 1
Set the destination
e-mail IP address
racadm config -g cfgIpmiPet -o
cfgIpmiPetAlertDestIpAddr -i 1
192.168.0.110
View the current test trap
settings
racadm getconfig -g cfgIpmiPet -i
<index>
where <index> is a number from 1 to 4
Table A-37. testtrap Subcommand Options
Option Description
-i Specifies the index of the trap configuration to use for the test Valid
values are from 1 to 4.

Dell IDRAC6 Specifications

General

Remote Management	Yes
Out-of-band Management	Yes
Remote KVM	Yes
Virtual Console	Yes
Version	6
Interface	Web-based
Features	Remote console, Virtual media
Security	SSL encryption
Protocols Supported	IPMI, SNMP
Authentication	Active Directory
Compatible Hardware	Dell PowerEdge servers (11th generation)
Remote Access	Yes
Alerts and Notifications	Email, SNMP traps
Power Management	Remote power on/off/reset, Power monitoring
Firmware Updates	Remote firmware updates via web interface or command line