GENERAL
B2050, B2350, B2650, B3150, WSM
G-34
[5] CHECK POINTS OF EVERY 400 HOURS
Changing Transmission Fluid
To avoid personal injury or death:
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug at the bottom of the
transmission case and drain the oil completely into the oil pan.
2. After draining reinstall the drain plug.
3. Fill with new KUBOTA SUPER UDT fluid up to the upper notch
on the dipstick.
4. After running the engine for a few minutes, stop it and check the
oil level again; add oil to prescribed level.
5. Properly dispose of used oil.
• If the 3-point hitch can not be raised by setting the
hydraulic control lever to the UP position after long term
storage or when changing the transmission oil, turn
steering wheel to the right and left several times to bleed air
from the system.
• Do not operate the tractor immediately after changing the
transmission fluid.
9Y1210982GEG0047US0
Oil capacity
B2050
B2350
B2650
Manual
Transmission
16.5 L
4.36 U.S.gals
3.63 Imp.gals
HST 17 L
4.49 U.S.gals
3.74 Imp.gals
B3150 HST
(1) Oil Inlet
(2) Dipstick
(3) Drain Plug
(4) Drain Plug (Both Sides)
A: Oil level is acceptable within this
range
[A] Without Mid-PTO
To Next Page
Loading...
Need help?
General
