3-31
Operation
Acknowledge: Trouble
Use this function to individually ac-
knowledge troubles.
If there is no trouble to acknowl-
edge, the System briefly displays the
following message and returns you to
the acknowledge menu:
No Trouble Exists
(If your System has a printer, it prints
the above message as well.)
If all the troubles are acknowledged,
the System displays the following
message and returns you to the
Acknowledge menu:
All Troubles Acknowledged
(If your System has a printer, it prints
the above message as well.)
If there is an unacknowledged
trouble, the System does not let you
acknowledge it if there are any unac-
knowledged alarms or supervisories.
Follow the instructions in Acknowl-
edge: Alarm and Acknowledge:
Supervsry previously described to
acknowledge them.
After you acknowledge all alarms and
supervisories, the System allows you
to acknowledge troubles. If there is at
least one unacknowledged trouble, the
System shows the most recent unac-
knowledged trouble on both lines of
the display, as in the following:
36-050 [custom message]
018 [trouble type] IN TBL
In the previous display, 36 is the
module number, 050 is the device
number, the message on the first line
is the custom message for that device,
018 indicates that this is the eigh-
teenth trouble, [trouble type] indicates
the type of trouble, and IN TBL identi-
fies the event as the occurrence of a
trouble.
Press ENTER to acknowledge the
trouble shown. The System prints a
message similar to the following
message and removes that trouble
from the unacknowledged trouble list:
ACK Trouble 36-050 16:11:44 Aug 2, 20xx
#18 [custom message], [trouble type]
[device type]
In the previous message, the time and
date are the time and date that the
trouble was acknowledged and 36-050
is the address.
To skip a trouble, press NEXT. The
System displays the next trouble to
acknowledge. When the System has
displayed all of the unacknowledged
troubles, it returns to the first Acknowl-
edge menu:
Acknowledge: Alarm Supervisry
Acknowledge: Security
Use this function to individually
acknowledge security conditions.
If there is no Security condition to
acknowledge, the System briefly
displays the following message and then
returns you to the Acknowledge menu:
No Security Exists
(If your System has a printer, it prints
the above message as well.)
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
