3-60
Operation
The System then sends information to
force this detector into pre-alarm. Once
it pre-alarms, or after a delay, the MXL
then restores the detector to its proper
pre-alarm setting.
Test: ASD_Devices
Use Test ASD_Devices to disable ASD
parameters and allow timely response
to test gas.
Select ASD_Devices and press ENTER.
The System tests the ASD devices
present in the System and displays the
following:
Testing Of ASD Device Enabled
Press ENTER again and the System
displays:
Testing Of ASD Device Disabled
Press ENTER to toggle between
Testing Enabled (Trouble In) and
Testing Disabled (Trouble Out). When
toggling between Testing Enabled and
Testing Disabled, there is a three
minute time period that separates the
two states.
Activating the ASD_Devices command
will post a Trouble into the System
which will be printed as:
TROUBLE IN 253 08:24:53 Aug 08, 20xx
#8- - - CERBERUS Pyrotronics---,
ASD Testing Enabled, MXL Panel
Pressing ENTER a second time will
cause the following message to be
printed out:
TROUBLE OUT 253 08:24:53 Aug 08, 20xx
#9- - - CERBERUS Pyrotronics---,
ASD Testing Disabled, MXL Panel
NOTE: If Test ASD_Devices is acti-
vated and left alone, the System will
automatically disable the test (time
out) after four hours. Test ASD_Devices
is inhibited while the System is initializ-
ing or resetting.
Test: Summarize
Use Test Summarize to ignore known
troubles, and instead view one summa-
rized trouble for an entire module. This
is typically used during installation and
commissioning.
Select Summarize and press ENTER.
The System displays the following
menu:
Select Mods ON OFF
Test: Summarize - Select_Mods
Use Test Summarize Select_Mods to
scroll through all installed (CSG-M)
module addresses and enable/disable
the summarize feature for each mod-
ule address. Choose Select_Mods and
press ENTER. The System displays
the following:
001 YES NO
Press NEXT and the System displays:
002 YES NO
The System flashes the currently
active summarize selection for the
module address. The operator may
then press the right
(Ø) or left (×)
arrow keys to highlight either YES or
NO and then press the ENTER key to
accept and program the selection.
When ENTER is pressed, the System
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
