SNTP COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
1029
sntp debug traceconfig
Modify SNTP client trace configuration
SYNTAX:
sntp debug traceconfig [state = <{disabled|enabled}>]
Download parameters. = <{disabled|enabled}>
where:
state Enable/Disable tracing.Command: software download OPTIONAL
Download parameters. Syntax : download filetype = <{firmware}> url = <string>
[username = <string>] [password = <string>] [filesize =
<string>] [targetfilename = <string>]
REQUIRED
SYNTAX:
sntp debug traceconfig filetype = <{firmware}>
url = <string>
[username = <string>]
[password = <string>]
[filesize = <string>]
[targetfilename = <string>]
where:
filetype The type of the file to be downloaded. REQUIRED
url Set the HTTP URL where the file is to be found including
remote filename.
REQUIRED
username Set the name to be used to authenticate to the download
server.
OPTIONAL
password Set the password the be used to authenticate to the
download server.
OPTIONAL
filesize Set the size of the file to be downloaded. OPTIONAL
targetfilename Set the filename used to save the file on the modem. OPTIONAL
To Next Page
Loading...
Need help?
General
