ETH COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
457
eth oam modify
Modify E-OAM configuration for an interface.
SYNTAX:
eth oam modify ifname = <{}>
[state = <{disabled|enabled}>]
[max-pdu-rate = <number{1-100}>]
[mru = <number{64-1518}>]
[tx-timeout = <number{1-86400}>]
[ll-timeout = <number{1-86400}>]
[oui = <string>]
[vendor-code = <number or string>]
[mode = <{passive|active}>]
[unidirectional = <{disabled|enabled}>]
[loopback = <{disabled|enabled}>]
[link-event = <{disabled|enabled}>]
[var-response = <{disabled|enabled}>]
where:
ifname The interface for which to configure E-OAM. REQUIRED
state Enable/disable E-OAM. OPTIONAL
max-pdu-rate Maximum number of PDUs per second. OPTIONAL
mru Maximum Receive Unit. OPTIONAL
tx-timeout Transmission timeout. OPTIONAL
ll-timeout Local Lost Link timeout. OPTIONAL
oui OUI to be used in Information OAM PDUs (system OUI if
left blank).
OPTIONAL
vendor-code Vendor Specific Information. OPTIONAL
mode E-OAM operational mode. OPTIONAL
unidirectional E-OAM unidirectional capability. OPTIONAL
loopback E-OAM loopback capability. OPTIONAL
link-event E-OAM link event capability. OPTIONAL
var-response E-OAM variable response capability. OPTIONAL
To Next Page
Loading...
Need help?
General
