SYSTEM COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
1071
system ra config
Configure remote access parameters.
SYNTAX:
system ra config name = <{}>
[state = <{disabled|enabled}>]
[secure = <{enabled|disabled}>]
[port = <number>]
[timeout = <number>]
[mode = <{Permanent|Temporary|Schedule}>]
[ipintf = <string>]
[randompassword = <{enabled|disabled}>]
[randomport = <{enabled|disabled}>]
[group = <string>]
[user = <string>]
[todschedule = <string>]
[systemservice = <{GUI|webservice}>]
where:
name Instance name REQUIRED
state Enable/disable RAD. OPTIONAL
secure Use secure mode (https). OPTIONAL
port The port number. OPTIONAL
timeout The timeout value. OPTIONAL
mode Mode Permanent or Temporary. OPTIONAL
ipintf The name of the xref to the IP interface. OPTIONAL
randompassword Create a random password. OPTIONAL
randomport Use a random port. OPTIONAL
group The name of the xref to the group keypath. OPTIONAL
user The name of the xref to the user keypath. OPTIONAL
todschedule The name of the xref to the ToD schedule. OPTIONAL
systemservice The system service type. OPTIONAL
To Next Page
Loading...
Need help?
General
